PERFORMANCE - IPE - H&R Springs - VW Central
H&R Lowering Springs - VW Scirocco III incl. R
H&R Lowering Springs - Audi RS3 Sportback Quattro 8V
H&R Lowering Springs - VW MK6 Golf R
H&R Lowering Springs - VW MK7 & MK7.5 Golf VII R
H&R Lowering Springs - VW MK6 Golf GTI & GTD
H&R Lowering Springs - VW Polo GTI
H&R 35MM LOWERING SUSPENSION SPRINGS
Golf 7/7.5 1.2T Si, 1.4T Si, 1.6TDi FWD 11/12>
Part Number: 28843-1
Front Lowering: 35mm
Rear Lowering: 35mm
Front Axle Weight: Up to 1010kg
Rear Axle Weight: Up to 940kg
Sale
H&R Lowering Springs - Audi S3 8V/8V.5 Sportback & Sedan - Quattro
Regular Price:
$630.00
Special Price
$549.95
H&R Lowering Springs - Golf MK8 GTI
Lowering Levels:
Front 40mm
Rear 40mm
Enhance the look of your vehicle with H&R Lowering Springs. H&R Sport Springs provide a lower center of gravity and reduce body roll for better handling. The progressive spring rate design provides superb ride quality and comfort. A lower wind resistance signature will make the vehicle more streamlined and improve gas mileage. If you are only looking to improve one part of your vehicle's suspension, you cannot go wrong with installing sport springs. Fun to drive, H&R Sport Springs are the number one upgrade for your vehicle.
Sporty look and performance
Progressive spring characteristics
Less weight by using high tension steel
TUV approved
Product Details
The ECS Billet Aluminum Manifold Port Boost Tap Kit conveniently adds three boost / vacuum ports to your Gen3 engine for any of your specific needs. Located on the left side of the intake manifold within the unused side intake port, this location provides a strong pneumatic signal and allows for an installation.
Through multiple design revisions and product testing, our team of engineers found that other methods of acquiring a manifold signal, such as spacing the MAP / IAT sensor on top of the intake manifold, lead to skewed data being transmitted to the ECU. We found that intake air temperatures were reading lower (15-20° F at WOT), ignition timing was off (as much as -5°) and air /fuel ratio was richer (+1.0 point by 5,000 RPM). This directly translated into engine power dropping by as much as 6 WHP on an untuned vehicle!
You can be certain that all critical data is not affected and your engine's ECU has all of its valuable information to properly adjust timing and fuel with our leading edge design! Engineered specifically for the Gen3 engine, we designed our Manifold Port Boost Tap with 3 ports, so you have multiple options to provide the strongest manifold signal to either your boost gauge, blow off valve, water meth switch or any other pneumatic device.
In house designed and built in the USA, our Boost Tap includes the following:
Black Anodized, Billet Machined 6061-T6 Aluminum Manifold Port Boost Tap
3 Vacuum Ports with 1/4" Hose Barb Fittings
3 Vacuum Set Screws
Medium Strength Thread Lock
OEM Securing Clip
Manifold Pierce Alignment Tools
In-house designed and made in America, you can expect nothing short of the best performance and longevity with this superior Manifold Port Boost Tap Kit from ECS Tuning!