Part No:
ESHY30NVKAS
RRP:
$850.00
Diameter [in]:
3"
Material:
Stainless Steel
Suppliers Product Group:
Axle Back System
Feature;
3″ Stainless steel pipe work
Varex rear Muffler
Direct swap with factory standard section
4″ double wall tips
Smartbox is NOT included
Installation instructions
Download Installation Instructions
Cat-Back System
3″ Cat-Back System With Varex in 304 Stainless Steel
Part No:
ESA45VKCS
RRP:
$2,120.00
Diameter [in]:
3
Material:
Stainless Steel
Suppliers Product Group:
Cat-Back System
:
Feature:
3″ cat back system
Polished 304 stainless steel mufflers
Brushed pipe work
Varex rear muffler
Fits to factory bumper tips
This is a direct replacement for Part Number 06H 131 111. - It will fit EA888 Gen 3 engine with IHI Turbo IS20 IS38
On a 2.0L Porsche Macan, this muffler delete gave an additional 10bhp during dyno tests.
Forge has developed this turbo outlet muffler delete pipe for the 1.8 and 2.0 petrol turbo (TSI) (EA888 engine). It has been designed with 3 points of contact to eliminate any possibility of resonation. This part will improve the sound of your turbo spooling and improve response due to its sleek single billet design that eliminates the restriction and turbulence caused by the OEM part.
• New control box and updated screen bargraph • Updated harness with streamlined connectors • New improved color coded obd2 harness • Read D.T.C's on command • Remove unwanted PIDs / gauge modes • Configure units individually for English/Metric • Calibrate vehicle speed reading • Read AFR in Lambda (vehicles with wideband) • Auto-detect available PIDs / sensors • Pre-configured analog inputs for P3 Sensors
The P3 Analog Gauge*This gauge IS NOT plug and play. Boost/vacuum hose to the engine is required and wiring needs to be completed for power, ground, and optional analog inputs.
4 Available Analog Readouts
Analog boost (yellow/purple/black - dedicated plug for analog boost sensor) *boost tap not included
Analog input 1 (brown wire - can read any 0-5 volt linear output sensor)
Analog input 2 (blue wire - can read any 0-5 volt linear output sensor)
Battery voltage (red wire / black wire - read through power and ground wires)
optional auto-dim feature (green wire - connect to any circuit that gets power only when the headlamps are on and enable feature in the configuration menu for the display to auto-dim when the headlamps are on)
OEM Vent Option
We install the display in an OEM vent for your vehicle to make your install even easier.
Analog gauge base kit includes
Integrated display
Analog Box control unit
Main harness
Hard-wire harness
Analog boost sensor *boost tap not included
Approximately 5' of 5/32" O.D. boost tubing with 5/32" I.D. hose at each end