Regular Price: $65.00
Special Price $55.25
Regular Price: $65.00
Special Price $55.25
Regular Price: $61.00
Special Price $51.01
Regular Price: $608.00
Special Price $515.99
Whiteline offset strut tops allow for extra negative camber and positive caster to improve steering response, steering feel and reduced movement to ensure wheel alignment stability through a high quality spherical bearing. Perfect for the high performance street or track day weapon, providing improved tyre life and extra grip during high speed / high load cornering.
Regular Price: $781.00
Special Price $663.85
Description:
Benefit Note:
The torque arm assists in controlling the engine and drivetrain forward and aft twisting motion. The torque arm is inherently soft due to the high compliance rubber bushing design and was built for comfort and not responsiveness or feel. Whiteline's torque arm mount bushing is built to handle the demands of high torque and power output engines by limiting the amount of movement the engine and drivetrain will place upon the pitch stop. Utilising low compliance bushing technology this eliminates the slop, twisting and shudder found in the OEM rubber bushings allowing for a faster, positive, responsive feel of power delivery on and off the throttle.
SKU | KDT975 |
---|---|
Foot Note 1 | Performance alloy arm |
Foot Note 2 | X heavy duty - induces NVH |
Foot Note 3 | 3 Year / 60,000Kms |
Components Per | 2 Brackets, 2 Bushings, 2 Tubes, 3 Bolts, 1 Washer, 1 Nut |
Sub brand | Performance |
EAN | 9319924462131 |
Regular Price: $389.00
Special Price $330.65
One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.
Regular Price: $184.00
Special Price $179.00
Regular Price: $769.00
Special Price $692.00
Description:
In the world of VW, the R32 with the iconic VR6 engine has achieved cult-like status. Leyo Motorsport has over the years gained enough experience to now touch an icon.
Air flowing through the OE air scoop is greeted by an enlarged high flow air filter and quickly fed into the engine, assisting power gains across the rev range especially in the higher rpm’s whether you on stock or tuned ECU.
Excessive heat from the engine bay is blocked by the heat shield.
LEYO Cold Air Intake System guarantees greater air induction volume, colder intake air temperature and smoother air flow for superior power gain. LEYO Cold Air Intake System was designed with the ultimate goal of maximum power gain.
Installation is simple and straight forward, no fabrication required.
*This product is only for use on the race track.
Specifications:
OEM fitment requires no fabrication.
3.5’inch diameter for greater air induction.
Track and dyno proven for greater horsepower gain.
Direct bolt on & easy installation.
Description:
Made from T6061 billet aluminum, LEYO DSG Oil Filter Housing not only adds aesthetic appeal to the engine bay, but specially designed fin also provides effective heat dispersion for the DSG under load. Heat resistant to prolong optimum operational temperature.
*Only fits 6 speed DSG DQ250 wet.
Specifications:
T6061 Billet aluminum construction.
Hard coat anodized finish for impeccable appearance and heat resistance.
Promotes oil heat dispersion.