Passat - Turbosmart - Integrated Engineering - Whiteline

Whiteline offset strut tops allow for extra negative camber and positive caster to improve steering response, steering feel and reduced movement to ensure wheel alignment stability through a high quality spherical bearing. Perfect for the high performance street or track day weapon, providing improved tyre life and extra grip during high speed / high load cornering.

Description:

Benefit Note:

The torque arm assists in controlling the engine and drivetrain forward and aft twisting motion. The torque arm is inherently soft due to the high compliance rubber bushing design and was built for comfort and not responsiveness or feel. Whiteline's torque arm mount bushing is built to handle the demands of high torque and power output engines by limiting the amount of movement the engine and drivetrain will place upon the pitch stop. Utilising low compliance bushing technology this eliminates the slop, twisting and shudder found in the OEM rubber bushings allowing for a faster, positive, responsive feel of power delivery on and off the throttle.

The Integrated Engineering MK5/MK6 FDS intercooler system was built from the ground up to offer the ultimate in performance for your vehicle. When increasing the power output of your engine it is extremely important to ensure it has the proper cooling to match. It packs a very large intercooler core into the space available, a full 54% larger than the OEM core. This large core delivers cool air to the engine under all circumstances, increasing power and torque and simultaneously reducing heat soak.  

One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.

EVAP Crossover Tube Relocation Kit for 2.0T FSI with IE Valve Cover

This recirculating catch can kit has been designed for use with the IE billet valve cover (IE part number: IEBAVC5) as a simple install solution for your billet valve cover and catch can. 
IE billet valve cover sold separately. 

Product Features