B6 (2005-2010) - Leyo Motorsport - Integrated Engineering

One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.

EVAP Crossover Tube Relocation Kit for 2.0T FSI with IE Valve Cover

Description:

In the world of VW, the R32 with the iconic VR6 engine has achieved cult-like status. Leyo Motorsport has over the years gained enough experience to now touch an icon. 

Air flowing through the OE air scoop is greeted by an enlarged high flow air filter and quickly fed into the engine, assisting power gains across the rev range especially in the higher rpm’s whether you on stock or tuned ECU. 

Excessive heat from the engine bay is blocked by the heat shield.

LEYO Cold Air Intake System guarantees greater air induction volume, colder intake air temperature and smoother air flow for superior power gain. LEYO Cold Air Intake System was designed with the ultimate goal of maximum power gain. 

Installation is simple and straight forward, no fabrication required.

*This product is only for use on the race track.

Specifications:

• OEM fitment requires no fabrication.

• 3.5’inch diameter for greater air induction.

• Track and dyno proven for greater   horsepower gain.

• Direct bolt on & easy installation.