Regular Price: $999.00
Special Price $950.00
Regular Price: $1,899.00
Special Price $1,779.95
Regular Price: $929.00
Special Price $836.00
This plug and play harness kit is required for IE TrueFlex ECU Tunes for VW and Audi MQB Gen 3 engines. This includes everything necessary for the flex-fuel sensor to send real-time data from your fuel system to the ECU and adjust for any content mix from 91 pump to full E85 automatically.
Kit includes:
This harness kit is fully assembled to proper lengths and includes everything needed to install in a clean and factory-like install. Disconnecting and cutting of factory soft fuel lines is required and should be completed with great care or by a professional.
TrueFlex is currently available for 2015-2018 MK7 GTI & A3 2.0T W/IS38. Stage 1 & 2, Golf R/S3, and 2019+ model years are coming soon!
This charge pipe upgrade Kit for 2.0T and 1.8T MK7/8V TSI engines includes two quality silicone intercooler inlet/outlet hoses and four high-strength band clamps for a direct installation. These hoses are a direct replacement for both IE FDS V2 Intercoolers and the stock factory equipped intercooler. Your new charge pipes feature a flow maximized design with no restrictions for optimized airflow.
Manufactured from multi-ply reinforced silicone for long-life and reliability against expansion or stretching under extreme boost pressures from upgraded turbos and tunes. The ends are molded with a inner flat edge that creates a stop for a perfect and easy no-fuss install and increased reliability against hoses popping off or leaking.
The Integrated Engineering MK5/MK6 FDS intercooler system was built from the ground up to offer the ultimate in performance for your vehicle. When increasing the power output of your engine it is extremely important to ensure it has the proper cooling to match. It packs a very large intercooler core into the space available, a full 54% larger than the OEM core. This large core delivers cool air to the engine under all circumstances, increasing power and torque and simultaneously reducing heat soak.
Regular Price: $1,899.00
Special Price $1,769.00
One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.
Regular Price: $184.00
Special Price $179.00
Add serious power and fun to your car without popping the hood! The IE POWERlink V4 Flash Cable is the key to uploading IE engine-specific tuning upgrades to your ECU, Simply plug into your vehicles OBD2 port and launch the app on your Apple or Android phone (or Windows laptop). Enjoy serious horespower, torque gains, increased acceleraton, faster 0-60 times, optimized drivability, improved responsiveness, multiple octanes, enthusiast drive mapping and more in only minutes!
Would rather use a laptop? No problem! IE Flash Wizard Software allows the IE POWERlink Tool to communicate with your vehicle’s ECU to flash software tunes, upgrade, update, data log, or read/write codes on any Windows 10+ powered laptop or tablet.
DEVICE | PORTS | OS | PROC. | POWER | RAM |
Laptop or Tablet |
Wifi & USB |
Windows 10 or newer |
32 or 64 bit |
1.0ghz or greater |
4GB or greater |
NOTE: Mobile flashing app requires an IE V4 POWERlink flashing cable and is not compatible with older V3 serial number units. Have a V3 and ready to go Mobile? Simply purchase a new V4 POWERlink to gain full mobile functionality.
Regular Price: $769.00
Special Price $692.00